Phase-pulse torque meter

The seller is blocked and sales of the product are suspended

Course project on discipline: "Electronic circuits and microcircuitry"
Theme of the project: "Phase-impulse torque meter"

Year: 2010

Task: It is necessary to develop a phase-pulse meter of torque. When developing it is necessary to consider the following:

1) the primary transducers are sensors with a pulsed output signal with an amplitude of 0.2 V and a pulse duration of 100 μs;

2) the engine speed may vary from 0 to 1500 rpm;

3) the measured parameter - the torque depends on the torsion angle of rotation, which can vary from 0 to 30 °;

4) measurement of the torsion angle of torsion should be carried out with an error of not more than ± 0.1 °;

5) the measurement result must be presented in digital form;

6) provide for the possibility of manually fixing the result for 1 minute;

7) the temperature regime of the device 20 ± 5 ° C;

It is necessary to select and calculate the elements of the meter circuit. The selected elements should not only provide the required operation algorithm, but also provide the specified measurement accuracy.

Content:
Terms of Reference for the course project ..... 3
Introduction ..... 4
1. Analysis of the technical specifications ..... 6
2. Overview of the used technical literature ..... 9
3. The choice and justification of the structural diagram of the meter ..... 10
4. Development of the circuit diagram of the meter ..... 12
5. The algorithm of the control program ..... 23
6. The calculation of the measurement error ..... 26
Conclusion ..... 28
References ..... 29

Scope of work:

    * Explanatory note, number of pages: 29, MS Word
    * Drawing of an electrical circuit diagram: A2, Compass-10
    * The list of elements to the electrical circuit diagram: 3 sheets A4, Compass-10